
105
10.1 Addive Modularity Linked mode
10. ASSEMBLING AND DEVICES COUPLING
The LiveCore™ unit can be used in mulple device conguraon to share informaon between device chassis.
This can enable large setups such as a large mul-device screen blend (Hard Edge and So Edge).
LiveCore™ units can be linked in two modes:
allows two units (except NeXtage 16) to share the combined resources
of up to all 24 inputs, 8 outputs, and 2 operator’s monitors using a set of three Livecore Link cables plus a
LAN cable for synchronizaon. Any input can be routed to any layer on any output, and any combinaon of
screens can be used, up to 8 outputs blended.
Analog Way cable
allows for up to four units to be used as part of the same Assembly on the
Verge™ console. The Device Sync connecon assists with synchronizaon between the various units. In
Associave Modularity conguraon, video informaon must be externally split and shared with all devices
in the Assembly.
Once the two devices are wired up, ensure that all devices have unique IP addresses on the network, and
that the gateway IP of all devices is set correctly. If you are not using a router on the network, set all of
the gateway IP addresses to the rst or last IP on the network, for example 192.168.2.1 and do not use this
address for any other device.
Lastly, connect to one of the two units, go to the SETUP >PRECONFIG >LINKED PAGE, select Linked mode,
and click Refresh to check the connecons. If all 5 connecon parameters are green, click Start and the units
will synchronize and self-congure for linked operaon. If any conguraon parameter is red, x the error
and click Refresh again. All units must be running the same rmware or you will not be able to iniate the
Link mode.
DEVICE MASTER DEVICE SLAVE
RJ-45
OPT-LINK (x3)
LINK 1
LINK 2
LINK 3
RJ-45
RJ-45
OUT IN
Web RCS
(Remote Control Soware)
ETHERNET HUB
Comentarios a estos manuales