
18
4.1.5 Iteraon Wizard
• Loading an iteraon:
In the le menu, select the LOAD opon.
Select the iteraon you want to load and
then press the Load buon to load this
iteraon and begin working on your
event setup.
• Exporng an iteraon to a USB key:
In the le menu, select TRANSFER then
select the EXPORT opon. Select the
iteraon you want to export then plug a
USB ash drive into one of the Verge™
USB connectors. Wait for the device to
appear in the Storage list, then select it and press the Export buon to start exporng this iteraon.
• Imporng an iteraon from a USB key:
In the le menu, select TRANSFER then select the IMPORT opon. Plug a USB ash drive into one of the
Verge™ USB connectors. Wait for the device to appear in the Storage list, then select it to display the
iteraons available. Select the iteraon you want to import then press the Import buon to start imporng
it into the current show (as a new iteraon index).
4.1.5 Iteraon Wizard
The Iteraon Wizard page is the rst step
you should go through once you have
loaded an empty iteraon. It allows you
to setup one device in just a few quick
steps:
Wizard Step 1:
In the Device Type eld, select the type
of device you want to control.
Select the Single or Synchronized opon
if you have a single device or if your
devices will synchronized for achieving
bigger screens (associave modularity).
When synchronized, all the sources must
be shared and congured the same way
on all devices.
Select the Linked with SLAVE opon, if
the device is linked to another compliant
device (addive modularity).
Select the Linked with LOE opon, if the
device is linked to a LiveCore Output
Expander (addive modularity).
If your devices have the 4K opon, make
sure to check the 4K box.
Select a quanty of devices then adjust
each device IP address to match your
network conguraon. Press the Next
buon to connue.
Comentarios a estos manuales