Analog-way Di-VentiX - DVX8022 Manual de usuario descargar pdf (Pagina 23)

Di-VentiX™ Chapter 3 : OPERATING MODE (continued)

PAGE 23

3-1. OPERATING WITH THE REMOTE CONTROL SOFTWARE (continued)

3-1-3. OPERATING IN MIXER MODE (continued)

 Double PIP transition:

• Create a frame with 2 black areas with a standard drawing software. The 2 black areas will be receiving the PIP

sources.

• Connect to the Di-VentiX the source providing the frame to be stored, and select the source.

• Click on the Logo & Frame tab, then click on the record frame tab: the device displays a white rectangle

corresponding to the frame selection area. As required adjust the position and size of the frame selection area with

the position & size functions.

• Adjust the Luma Key level to get to the desired Luma Keying.

• Click on STORE and select a frame memory (Up to 6). The memorization starts and will take about 2 minutes.

• Display onto the MAIN & PREVIEW outputs, the 2 sources to be used for the PIPs.

• Select an EFFECT key. Then click on the Effect tab and select Double PIP type. Then select the holding

duration.

• Click on the Background and Inlay button and select a frame.

• Click on TAKE: the frame store is displayed onto the MAIN output together with the 2 PIP.

• Adjust the position & size of each PIP.

• Adjust the mask size & position of each PIP in such manner that the 2 PIP will not be superposed into the black

areas.

• Click on the Background and Inlay button and select inlay = yes if you want to set the PIP in background.

NOTE:

You can change the background frame during a double PIP.

Frame store Main source Preview source

The 2 PIP & the frame store are displayed onto the MAIN output

Inlay = no Inlay = yes

Figure 25: Double PIP.

Figure 26: Double PIP effect window.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 142 143

Sin comentarios

Analog-way Di-VentiX - DVX8022 Manual de usuario Pagina 23