Analog-way Di-VentiX - DVX8022 Manual de usuario descargar pdf (Pagina 15)

Di-VentiX™ Chapter 2 : CONNECTING (continued)

PAGE 15

2-2. CONNECTING A CONTROL DEVICE FOR USING THE REMOTE CONTROL SOFTWARE

Your Di-VentiX is shipped with a Windows compatible Remote Control Software (3.5" disk). This software allows you

to control and do all adjustments by a simple mouse click.

NOTE:

Preferably use Windows NT, 2000, or XP for LAN operation.

2-2-1. CONNECTING TO THE RS-232 PORT

- Connect the serial port of your control device to the RS-232 port (DB9 Female connector) of the Di-VentiX with

a straight

cable (DB9 Female / DB9 Male).

- Speed transmission: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

- Pin-out:

PIN # FUNCTIONS

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

2-2-2. CONNECTING TO THE LAN PORT

- Connect the LAN port (RJ45 connector) of the Di-VentiX to your network according to your installation.

2-3. CONNECTING THE REMOTE KEYPAD

2-3-1. CONNECTING TO A Di-VentiX WITH THE RS-232 PORT

 Turn OFF your Di-VentiX (rear panel switch).

 Connect the RS-232 connector (DB9 female) of your Di-VentiX to the DB9 male connector of the REMOTE

KEYPAD with the supplied DB9 M/F cable.

 Turn ON your Di-VentiX (REAR panel switch).

NOTE:

The REMOTE KEYPAD is powered by the Di-VentiX via its DB9 (RS-232) connector.

Figure 12

2-3-2. CONNECTING TO A NETWORK (LAN)

 Connect the power supply to a power outlet and to the DC-IN connector (rear panel).

 Connect the REMOTE KEYPAD to your network according to your installation.

Figure 13

DB9 female (Rear panel of the DVX8022)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 142 143

Sin comentarios

Analog-way Di-VentiX - DVX8022 Manual de usuario Pagina 15