Analog-way OPS300 Manual de usuario descargar pdf (Pagina 51)

Input selection settings

Source Input selection

Source output selection

Same as MIXER Mode.

* NOTE *: if you want to use HDCP content from your sources, be sure to plug HDCP compliant screens or

projectors. If it’s not the case, the output image could be disabled.

B- SETTINGS IN NATIVE MATRIX MODE

Output selection settings

To set up the outputs, go in the Output #1 or Output #2 menu and choose rst the appropriate format/reso-

lution and then the adapted rate for your screens by using the knob button and the [ENTER] button.

Output# → Output Format → Output rate

You can also in the Output #2 menu, synchronise all the changes from the Output #1 to the Output #2 by

checking the case Synch w/Out 1. It allows you to set up both outputs at the same time.

Output #2 → Synch w/Out 1

Try to use the native resolution of your screens/projectors in order to obtain the best image quality.

* NOTE *: The output status can provide you all information about the output in real time. This feature is

particularly needed when HDCP is used thanks to the HDCP status.

*All changes have to be validated by pressing the [OK] button in order to be saved*

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Sin comentarios

Analog-way OPS300 Manual de usuario Pagina 51